2005 – 2013 Honda Civic Key Battery Replacement Guide

Introduction

Replacing the battery in your Honda Civic key fob is an essential maintenance task. This guide will show you how to replace the battery in a Honda Civic key fob, specifically for models from 2005 to 2013. The process is straightforward and requires only a few tools.

Tools and Materials Needed

Before you start, make sure you have the following tools and materials:

• Precision screwdriver set
• CR1616 coin battery

You can purchase a precision screwdriver set for about $4 on Amazon. The exact battery model you need is CR1616, which is also available online.

Step-by-Step Guide

Step 1: Remove the Screw

First, flip the key fob over. You will see a small screw at the base. Use a precision screwdriver to remove this screw. Depending on your key fob, this screw might be a bit tight, so you may need to apply some pressure.

Step 2: Separate the Key Fob

Once the screw is removed, you need to locate a small notch in the middle of the key fob. Insert a small flat-head screwdriver into this notch and twist it. The base of the key fob will start to separate. The only thing holding it together now is a small notch at the top.

Pull from the base and then towards you to remove this section.

Step 3: Access the Internal Components

Inside, you will find the internal piece containing the battery. Set aside the outer shell of the key fob for now. There is another notch in the upper right corner of this internal piece. Insert your flat-head screwdriver into this notch and twist to pop it open.

Step 4: Remove the Old Battery

With the internal piece open, you will see the battery. To remove it, insert your screwdriver under the battery and lift it out. The battery you need to replace is a CR1616 3-volt coin battery.

Step 5: Insert the New Battery

Take your new CR1616 battery and insert it into the slot. The easiest way is to get it under the right area and press it into place. The prongs holding the battery aren’t too tight, so this should be straightforward.

Step 6: Reassemble the Key Fob

Now that the new battery is in place, you can reassemble the key fob. Start by snapping the internal piece back together. Make sure the buttons are aligned correctly.

Next, place the internal piece back into the outer shell. Remember the small ridge at the top of the shell; make sure this ridge goes in first to ensure everything closes properly.

Finally, reinsert the screw at the base of the key fob.

Conclusion

And that’s it! You’ve successfully replaced the battery in your Honda Civic key fob from 2005 to 2013. This simple maintenance task can save you time and money. Always keep a spare CR1616 battery on hand, so you’re prepared when your key fob battery dies.

FAQs

What type of battery does my Honda Civic key fob need?

Your Honda Civic key fob requires a CR1616 3-volt coin battery.

Do I need any special tools to replace the battery?

A precision screwdriver set is recommended for this task. These are affordable and available online.

How often should I replace the key fob battery?

Typically, the key fob battery should last between 1 to 2 years, depending on usage.

What should I do if the key fob doesn’t work after replacing the battery?

Make sure the battery is inserted correctly. Check for any damage to the key fob and ensure all components are properly aligned.

Can I use a different type of battery?

No, it’s recommended to use the specified CR1616 battery for optimal performance.

Where can I buy the CR1616 battery?

You can purchase the CR1616 battery on Amazon or at most electronics stores.