Chevrolet Malibu Key Fob Battery Replacement Guide (2004 – 2012)

Introduction

Replacing the battery in your Chevrolet Malibu key fob is a simple process that can save you time and money. You don’t need any specialized tools or skills. In this guide, I will walk you through the steps to replace the battery in models from 2004 to 2012.

All you need is a CR2032 battery and a flathead screwdriver. Let’s get started!

Tools and Materials Needed

Before you begin, gather the following items:

• CR2032 battery
• Flathead screwdriver

Step-by-Step Instructions

Step 1: Locate the Indentation

First, look at the bottom right of your key fob, next to where the key ring attaches. You will see a small indentation along the seam of the plastic. This is where you will insert your flathead screwdriver.

Step 2: Insert the Screwdriver

Take your flathead screwdriver and insert it into the indentation. Once the screwdriver is in place, gently twist it. This action will start to open up the key fob. Be careful not to exert too much force to avoid damaging the plastic.

Step 3: Open the Key Fob

After twisting the screwdriver, you can pull the key fob apart with your fingers. Set the back piece aside for now. You will now have access to the internal battery.

Step 4: Remove the Circuit Board

To access the battery, you need to lift the circuit board out of the rubber housing. Gently grab the circuit board with your thumb and pull it out. This will allow you to slide the old battery out of the housing.

Step 5: Replace the Battery

Dispose of the old battery properly. Take your new CR2032 battery and make sure the positive side is facing up. You should see a plus sign and some text on this side of the battery. Slide the new battery into the metal housing and push it down firmly.

Step 6: Reassemble the Key Fob

With the new battery in place, you can start to reassemble the key fob. Take the front piece of the fob that has the rubber component and drop the circuit board back into place. Ensure it is sitting down nicely before you take the back piece of plastic and squeeze it back on.

Step 7: Test the Key Fob

Once everything is back together, your key fob should be good to go. Test the buttons to make sure the new battery is working correctly.

Conclusion

Replacing the battery in your Chevrolet Malibu key fob is a straightforward task that you can complete in under five minutes. With just a CR2032 battery and a flathead screwdriver, you can save yourself the hassle and expense of going to a dealer or a locksmith.

If you found this guide helpful, feel free to let me know in the comments or by giving this post a like. For more tutorials on key fob battery replacements for various makes and models, visit our website at fobbattery.com.

FAQ

What type of battery do I need?

You need a CR2032 battery.

Where can I buy the CR2032 battery?

You can purchase it on Amazon or at any local electronics store.

Do I need any special tools?

No, you only need a flathead screwdriver.

How long does the replacement take?

The entire process takes under five minutes.

What should I do with the old battery?

Dispose of the old battery properly, following local regulations for battery disposal.

Can I use a different type of battery?

No, it is recommended to use the CR2032 battery to ensure compatibility.

What if my key fob still doesn’t work?

Ensure the battery is installed correctly and the circuit board is seated properly. If it still doesn’t work, you may need to consult a professional.

Is this guide applicable to other car models?

This guide is specifically for Chevrolet Malibu models from 2004 to 2012. For other models, refer to specific instructions.