Chevrolet Avalanche Key Fob Battery Replacement Guide (2007 – 2013)

Introduction

Replacing the battery in your Chevrolet Avalanche key fob is a straightforward process that takes under five minutes. Whether your key fob has stopped working or you’re just preparing for the future, this guide will walk you through the steps required to replace the battery.

All you need is a CR2032 battery and a flathead screwdriver. This simple DIY task can save you a trip to the dealership and get your key fob working like new again.

Tools and Materials Needed

• Flathead screwdriver
• CR2032 battery

If you don’t have a CR2032 battery, you can easily purchase one online. There’s a link in the description that will take you to Amazon where you can buy this battery for just a few dollars.

Step-by-Step Instructions

Step 1: Locate the Indentation

First, look at the bottom of the key fob. You will see a small indentation in the plastic along the seam between the two halves. This is where you will insert your flathead screwdriver.

Step 2: Insert the Screwdriver

Insert the flathead screwdriver into the indentation. Push in gently until the screwdriver is stuck in there. Once it’s secure, twist the screwdriver. You should hear a little popping sound, indicating that the two halves of the key fob are separating.

Step 3: Separate the Halves

After you hear the popping sound, use your fingers to pull the key fob apart. Be careful to avoid damaging the indentation or the plastic casing. Set the back section of the plastic down.

Step 4: Remove the Circuit Board

Gently lift up the circuit board from the key fob. Once the circuit board is lifted, you can easily slide out the old battery using your thumb. Dispose of the old battery properly.

Step 5: Insert the New Battery

Take your new CR2032 battery and make sure the positive side (the side with the plus sign and battery information) is facing up. Slide the new battery into place.

Step 6: Reassemble the Key Fob

Pick up the front section of the plastic casing that has the rubber in it. Drop the circuit board back into its place. Then, take the back section of the plastic and place it on top. Squeeze the two halves back together until they snap into place.

Conclusion

And that’s it! Your key fob should now be working with the new battery. This simple process can save you time and money. If you found this guide helpful, feel free to let us know in the comments or by giving this guide a like.

If you ever need to replace another key fob battery, we have videos and guides for almost every make and model on our website, fobattery.com.

Frequently Asked Questions (FAQ)

What type of battery does the Chevrolet Avalanche key fob use?

The Chevrolet Avalanche key fob uses a CR2032 coin battery.

How long does it take to replace the key fob battery?

Replacing the battery takes under five minutes.

Do I need any special tools to replace the battery?

No, you only need a flathead screwdriver.

Can I buy the CR2032 battery online?

Yes, you can purchase the CR2032 battery online. There’s a link in the description that takes you to Amazon.

What should I do if my key fob still doesn’t work after replacing the battery?

Check to make sure the battery is inserted correctly with the positive side facing up. If it still doesn’t work, there may be an issue with the key fob itself.

Is it cheaper to replace the battery myself?

Yes, replacing the battery yourself is cheaper than going to a dealership.

Where can I find more information on key fob battery replacements?

You can find more information and guides on our website, fobattery.com.