Introduction
Replacing the battery in your Subaru Crosstrek key fob is a simple task that you can do at home. This guide will walk you through the process step-by-step. You’ll need a CR1620 battery and a flathead screwdriver to get started.
Tools and Materials Needed
Before you begin, make sure you have the following items:
- Flathead screwdriver
- CR1620 battery
You can purchase a CR1620 battery from various online retailers, such as Amazon.
Step 1: Locate the Slot
The first step is to locate the slot in the plastic casing of your key fob. This slot is near the key ring area. Insert your flathead screwdriver into this slot and twist to create a separation between the two halves of the device.
Step 2: Open the Key Fob
Once you have created a separation, continue working your way down the edge of the key fob with your screwdriver. Gently pry it open until the back part comes off. Set this part aside for now.
Step 3: Remove the Battery Housing
Inside the key fob, you will see a component that houses the battery and buttons. Carefully remove this component. You will notice small pieces of plastic that hold it in place.
Step 4: Pry Open the Battery Housing
Hold the sides of the battery housing that do not have plastic pieces. Use your flathead screwdriver to lift and pry open the housing. You may need to repeat this process on all sides to fully release the locking mechanism.
Step 5: Remove the Old Battery
With the battery housing open, use your flathead screwdriver to lift the old CR1620 battery out. Insert the screwdriver at the top left side of the battery and gently lift it out. This requires very little pressure.
Step 6: Insert the New Battery
Take your new CR1620 battery and make sure the positive side with the text is facing down. Click the new battery into place in the housing.
Step 7: Reassemble the Key Fob
Now, reassemble the key fob by lining up the two halves and clicking them back together. Ensure everything is secure and in place. You can now test your key fob to make sure it works properly.
Conclusion
If you followed these steps, your key fob should be working perfectly with its new battery. This simple maintenance task can save you time and money by avoiding a trip to the dealership.
FAQs
What type of battery does the Subaru Crosstrek key fob use?
The Subaru Crosstrek key fob uses a CR1620 battery.
Where can I buy a CR1620 battery?
You can buy a CR1620 battery from various online retailers, such as Amazon.
How often do I need to replace the key fob battery?
Typically, a key fob battery lasts about 2-3 years, but this can vary based on usage.
Can I use any flathead screwdriver to open the key fob?
Yes, you can use any flathead screwdriver that fits into the slot of the key fob.
What should I do if my key fob still doesn’t work after replacing the battery?
Ensure that the battery is correctly installed with the positive side facing down. If it still doesn’t work, there may be another issue with the key fob.