How to Replace the Key Fob Battery in a Ford Expedition (2010-2017)

Introduction

Maintaining your vehicle’s key fob is crucial to ensure smooth and uninterrupted access to your Ford Expedition. One of the most common issues you might face is a dead key fob battery. In this guide, I will walk you through the process of replacing the battery in your Ford Expedition key fob, specifically for the models from 2010 to 2017.

Identifying the Key Fob

First, let’s make sure we have identified the correct key fob. The Ford Expedition models from 2010 to 2017 use an integrated key fob that houses the battery. This key fob has a distinctive design with a line running around its edge, which separates the two main pieces of the fob.

Tools Required

You don’t need any specialized tools to replace the battery. In fact, a simple key or a small flathead screwdriver will suffice. The key will help you to leverage the fob open and access the battery compartment.

Step-by-Step Battery Replacement

Now, let’s dive into the step-by-step process of replacing the battery:

Step 1: Locate the Notch

First, hold the key fob so that the key is in the upper right corner. You will notice a small notch near this area. This notch is designed to help you open the fob.

Step 2: Separate the Two Pieces

Insert another key or a small flathead screwdriver into the notch. Apply some leverage and twist gently. This action will start to separate the two pieces of the fob. You might also find it helpful to apply pressure near the keyring attachment to further pry the pieces apart.

Step 3: Access the Battery Compartment

Once you have separated the two pieces, you will see a rubber backing. Ensure that this rubber backing stays in place or is put back properly after replacing the battery. The battery used in this key fob is a CR2032 coin battery.

Step 4: Remove the Old Battery

The old battery can be easily removed by tapping it out or gently prying it out with your fingers. Be cautious not to damage any internal components.

Step 5: Insert the New Battery

Take a new CR2032 battery. Ensure that the positive side, which has the lettering, is facing you. Place the battery into the compartment.

Step 6: Reassemble the Key Fob

Once the new battery is in place, align the two pieces of the fob and snap them back together. Ensure that the pieces are securely attached to avoid any issues.

Where to Buy the Battery

If you need to purchase a new CR2032 battery, you can easily find them online. I recommend buying from Amazon.com for convenience.

Conclusion

Replacing the battery in your Ford Expedition key fob is a straightforward process that requires minimal tools and time. By following these steps, you can ensure your key fob remains functional and reliable.

FAQs

How often should I replace the key fob battery?

Typically, a key fob battery lasts between 2 to 3 years. However, if you notice a decrease in range or the fob stops working, it’s time to replace the battery.

Can I use any other battery type?

No, you should only use a CR2032 coin battery for this specific key fob model. Using a different type could damage the fob.

Do I need to reprogram the key fob after battery replacement?

No, replacing the battery does not require reprogramming the key fob. It should work immediately after the new battery is installed.

What if my key fob still doesn’t work after replacing the battery?

If your key fob doesn’t work after replacing the battery, check if the battery is correctly installed with the positive side facing up. If it still doesn’t work, there might be an issue with the fob itself, and you may need to consult a professional.

Where can I find more information about my Ford Expedition key fob?

For more detailed guides and information, you can visit this link.