Dodge Durango Key Fob Battery Replacement (2004 – 2010)

Introduction

Replacing the battery in your Dodge Durango key fob is a simple process that you can easily do at home. No need to pay a professional. This guide will walk you through the steps to replace the battery in your key fob, which is used in Durangos from 2004 to 2010.

The only tool you’ll need is a flathead screwdriver and a new CR2032 coin battery. You can purchase the battery online for a few dollars. Let’s get started!

Tools and Materials Needed

• Flathead screwdriver
• CR2032 coin battery

Step-by-Step Guide

Step 1: Locate the Slot

First, look at your key fob. You’ll notice a small indentation or slot. This is where you will insert your flathead screwdriver.

Step 2: Insert the Screwdriver

Take your flathead screwdriver and insert it into the slot. Gently twist the screwdriver until you see the key fob start to open. Be careful not to apply too much pressure to avoid damaging the key fob.

Step 3: Open the Key Fob

Once you have a small opening, you can use your fingers to pull the key fob apart. If it’s still tight, use the screwdriver to twist a bit more until it comes free. Set the two halves of the key fob aside.

Step 4: Remove the Rubber Buttons

Inside the key fob, you’ll see a rubber component with buttons. Carefully lift this rubber piece and set it aside. This will expose the battery compartment.

Step 5: Remove the Old Battery

Now that you can see the battery, use your fingernail or the flathead screwdriver to lift the old CR2032 battery out of its compartment. It should pop out easily.

Step 6: Insert the New Battery

Take your new CR2032 battery and make sure the positive side is facing down. Click it into place in the battery compartment.

Step 7: Reassemble the Key Fob

Place the rubber component with the buttons back into the key fob. Make sure it sits nicely in place. Then, take the two halves of the key fob and click them back together.

Conclusion

And that’s it! You’ve successfully replaced the battery in your Dodge Durango key fob. This simple process can save you time and money. If you found this guide helpful, feel free to leave a comment or like. For more information on changing key fob batteries for various makes and models, visit our YouTube channel or our website at fobbattery.com. Thank you for reading!

FAQ

How often should I replace the key fob battery?

Key fob batteries typically last between 1-2 years. If your key fob is not working as well as it used to, it might be time for a replacement.

What type of battery does the Dodge Durango key fob use?

The Dodge Durango key fob uses a CR2032 coin battery.

Can I use any brand of CR2032 battery?

Yes, any brand of CR2032 battery will work as long as it fits properly.

What if my key fob still doesn’t work after replacing the battery?

If your key fob doesn’t work after replacing the battery, check to make sure the battery is installed correctly. If it still doesn’t work, the key fob itself might be damaged and may need to be replaced.

Where can I buy a CR2032 battery?

You can purchase a CR2032 battery online, at most electronics stores, or in the battery section of many supermarkets.

Do I need to reprogram my key fob after replacing the battery?

No, replacing the battery should not affect the programming of your key fob.