How to Replace the Battery in a 2006-2014 Honda Ridgeline Key Fob

Introduction

Maintaining your vehicle’s key fob is essential for smooth operation. In this guide, I’ll walk you through the steps to replace the battery in a 2006-2014 Honda Ridgeline key fob. This process is straightforward and only requires a few tools.

Tools and Materials Needed

Before starting, gather the necessary tools and materials. This will make the process quicker and more efficient.

• CR1616 coin battery
• Precision screwdriver set

Step 1: Remove the Back Screw

First, flip the key over to its backside. You’ll notice a small Philips screw. Use a precision screwdriver to remove this screw. It’s a tiny screw, so be careful not to lose it. The first time you do this, it might be a bit tight.

Step 2: Separate the Key Fob

Next, look at the lower left mid-side of the key fob. There is a small indentation. Insert the Philips screwdriver into this indentation and twist. This will give you the leverage to separate the base from the two pieces of the key fob. Pull the pieces apart gently.

Step 3: Remove the Internal Components

Once the key fob is open, you can easily pull out the internal components. Set the outer case aside for now. You’ll see another indentation in the upper right of the internal part. Insert the Philips screwdriver here and twist to access the battery compartment.

Step 4: Replace the Battery

The battery in the key fob is a CR1616 3-volt coin battery. Make sure the positive side of the new battery is facing away from you when you insert it. The battery should pop into place easily. Ensure there is no lettering facing you once the battery is in place.

Step 5: Reassemble the Key Fob

With the new battery in place, reassemble the internal part of the key fob. Ensure that the lights on the key fob are working. Next, place the internal components back into the outer casing. Align the upper lip with the ridge on the casing first. This will make it easier to snap the rest of the base together.

Step 6: Secure the Key Fob

Finally, reinsert the small Philips screw you removed earlier. Tighten it securely, but be careful not to over-tighten. Your key fob should now be fully functional with a new battery.

Conclusion

Replacing the battery in your Honda Ridgeline key fob is a simple task that can save you time and money. With just a few tools and the right battery, you can ensure your key fob remains in good working condition.

FAQs

What type of battery does the Honda Ridgeline key fob use?

The Honda Ridgeline key fob uses a CR1616 3-volt coin battery.

How often should I replace the key fob battery?

It’s recommended to replace the key fob battery every 1-2 years, depending on usage.

Can I use a different type of battery?

No, it’s best to use the specified CR1616 battery to ensure proper functionality.

What if my key fob still doesn’t work after replacing the battery?

Ensure the battery is installed correctly. If it still doesn’t work, there may be an issue with the key fob itself.

Is it difficult to replace the key fob battery?

No, the process is straightforward and can be done in a few minutes with the right tools.

Do I need to reprogram the key fob after replacing the battery?

No, replacing the battery does not require reprogramming the key fob.

Where can I buy the replacement battery?

You can purchase the CR1616 coin battery on Amazon or at most electronics stores.