Jeep Cherokee Key Fob Battery Replacement (2014 – 2021)

Introduction

The Jeep Cherokee key fob, used from 2014 to 2021, runs on a CR2032 coin battery. Replacing this battery at home is a simple task that can save you time and money. In this guide, I will walk you through the steps to change the battery in your key fob.

Tools and Materials Needed

Before you start, make sure you have the following tools and materials:

• Flathead screwdriver
• CR2032 battery

You can easily purchase a CR2032 battery from Amazon.com for a few dollars.

Step 1: Locate the Key Fob Separation

First, identify the point where the two halves of the key fob meet. This is usually located at the bottom, where the key ring is attached. You will notice a small separation in the plastic.

Step 2: Open the Key Fob

Insert the flathead screwdriver into the separation and gently wiggle it until the screwdriver slides in. Twist the screwdriver to start separating the two halves. You can use your fingers to pull them apart once they start to separate.

Step 3: Remove the Rubber Component

Inside the key fob, you will see a rubber component that houses the circuit board. Carefully remove this component and set it aside. Be gentle to avoid damaging the circuit board.

Step 4: Remove the Old Battery

Use your finger or the flathead screwdriver to carefully remove the old CR2032 battery. Dispose of the old battery properly.

Step 5: Insert the New Battery

Take the new CR2032 battery and ensure that the positive side, which has the text, faces down. Slide it into place until it clicks in.

Step 6: Reassemble the Key Fob

Place the rubber component back on top of the new battery. Align the two halves of the key fob and press them together until they click back into place.

Conclusion

And that’s it! You’ve successfully replaced the battery in your Jeep Cherokee key fob. This simple task can be done in just a few minutes, saving you the hassle of visiting a dealership or a service center.

FAQ

How often should I replace the key fob battery?

Typically, you should replace the key fob battery every 1-2 years, depending on usage.

What should I do if the key fob doesn’t work after replacing the battery?

Ensure the battery is installed correctly with the positive side facing down. If it still doesn’t work, the issue might be with the circuit board or another component.

Can I use any other type of battery?

No, it is recommended to use a CR2032 battery for the Jeep Cherokee key fob to ensure proper functionality.

Is it safe to replace the battery myself?

Yes, replacing the battery yourself is safe and straightforward as long as you follow the steps carefully.

What should I do with the old battery?

Dispose of the old battery at a designated battery recycling location to ensure proper disposal and environmental safety.

Where can I buy a CR2032 battery?

You can purchase a CR2032 battery from Amazon or any local electronics store.